ESSMO Fluorescent Yellow Matte Solid Heat Transfer Vinyl HTV Sheet T-Shirt 20" Wide Iron On Heat Press DP26 20"x108"

<p>Material Specification:</p><ul><li>PU Composition</li><li>Thickness:198 Microns / 7.8 Mils (Please make sure plotter is capable of cutting such thickness)</li><li>Heat pressure sensitive backing</li><li>Matte Finish</li></ul><p>Application Instruction (Home Iron)</p><ul><li>Set iron dial between Cotton and Linen</li><li>Cover design with Kraft paper or non-stick cover sheet</li><li>Place on flat, hard surface (ironing board not recommended)</li><li>Press iron with medium/firm pressure (do not slide iron)</li><li>Press each section of design for 10-15 seconds</li><li>If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds</li><li>let it cool for about 30-45 seconds and then gently peel back the clear plastic until it is completely removed.</li></ul><p>Application Instructions (Heat Press)</p><ul><li>Cut in reverse</li><li>Weed excess material</li><li>Preheat all fabric prior to pressing for best results</li><li>Apply design at 305F/150C-160°C for 12-15 seconds</li><li>let it cool for about 30-45 seconds&nbsp;and then gently peel back the clear plastic until it is completely removed.</li></ul><p>Applies to:</p><ul><li>100% Cotton</li><li>Poly / Cotton Blends</li><li>100% Polyester</li><li>Leather</li></ul><p>Laundering:</p><ul><li>Wait 24 hours before 1st wash</li><li>Machine wash warm or cold / mild detergent (Max 60°C)</li><li>Dry on normal dryer setting</li><li>Do not bleach or dry clean</li></ul>

• PU Composition
• Thickness:198 Microns / 7.8 Mils (Please make sure plotter is capable of cutting such thickness)
• Heat pressure sensitive backing
• Matte Finish

Application Instruction (Home Iron)

• Set iron dial between Cotton and Linen
• Cover design with Kraft paper or non-stick cover sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
• let it cool for about 30-45 seconds and then gently peel back the clear plastic until it is completely removed.

• Cut in reverse
• Weed excess material
• Preheat all fabric prior to pressing for best results
• Apply design at 305F/150C-160C for 12-15 seconds
• let it cool for about 30-45 secondsand then gently peel back the clear plastic until it is completely removed.

Applies to:

• 100% Cotton
• Poly / Cotton Blends
• 100% Polyester
• Leather

• Wait 24 hours before 1st wash
• Machine wash warm or cold / mild detergent (Max 60C)
• Dry on normal dryer setting
• Do not bleach or dry clean